XSAH-S2 Concrete Screw-Anchor Hex 316 Stainless Seismic C1

Easy to install with the new conical shape of the anchor tip and cutting groves, the XSAH-S2 provides low-levels of drilling and driving effort. Cutting its own thread into the concrete when installed, the fixings can be made close to the edge with the non-expanding anchor.

Installation can be completed with the use of a impact screwdriver, XSAH-S2 can be a permanent or temporary fixings.

The advantage of the ETA assessment allows for use in cracked and uncracked concrete and under seismic* C1 conditions in some application.

Application

• Anchor moderate to heavy loads in cracked and non-cracked concrete
• Railings and handrails, steel beans, wooden beams, brackets, pipeline, cable routes and more
• Without assessment, can also be used in compression-resistant natural stone, various solid bricks and green concrete

Advantages

• European Technical Assessment for anchoring in cracked and uncracked concrete (Option 1) for concrete screws in sizes ø 6, 8, and 10
• With up to 3 embedment depths, it is versatile for high loads or low levels of drilling and installation effort
• Easy to apply due to conical shape and cutting grooves on the tip
• Easy to screw in due to optimised tip and thread geometry
• Approved for use under seismic conditions of category C1*
• Approved for use under fire exposure
• Small drill hole diameter, small edge and axial gap
• Rapid push-through installation with an impact screwdriver without torque regulation
• No curing times – can be loaded immediately
• Adjustable to compensate for unevenness (Ø8 - Ø10 mm)
• Can be fully removed
• Wide range of possible applications through numerous variants

*For approved anchors in seismic conditions please see technical data sheet